| |
Technical Characteristics
|
| |
" Navyug (India) Limited " V-Belts are manufactured under strict vigilance and observation of the state of art of modern technology with reinforcement of highly shock - load resistant synthetic cords combined with special rubber compound and ultimately jacketed to obtain maximum life and smooth run of the drive.
A. Cover
The bias-cut cover fabric is impregnated with special rubber to protect the inner part
of the belts and provide strong abrasion resistance on the pulley groove.
B. Tension Member
The load carrying cords ..are tough polyester / aramide cords that have been specially treated to temper the ,cords to their point of high strength, low elongation and
greater resistance to bending fatigue.
C. Top Compression Section
The rubber used in this section is compounded to withstand sudden shock loads and to keep the belt flexing readily when passing over the pulleys.
D. Insulation Section
The insulation section holds the tension binding section for extra strong adhesion between cords and the top and bottom compression section.
E. Bottom Compression Selection
This section holds the normal cross section of the belts and is compounded to resist compression fatigue and heat for longer service life. |
| |
| Section | Force (N) |
Deflection 0.0115 PER mm of Span |
| SPZ | 67 to 95 | 10 to 1.5 |
| | 100 to 140 | 1.5 to 2.5 |
| SPA | 100 to 132 | 1.5 to 2.5 |
| | 140 to 200 | 1.5 to 2.5 |
| SPB | 160 to 224 | 1.5 to 2.5 |
| | 236 to 315 | 1.5 to 2.5 |
| SPC | 224 to 355 | 1.5 to 2.5 |
| | 375 to 560 | 1.5 to 2.5 |
| A | 80 to 140 | 1.5 to 2.5 |
| B | 125 to 200 | 1.5 to 2.5 |
| C | 200 to 400 | 1.5 to 2.5 |
| D | 355 to 600 | 1.5 to 2.5 |
| E | 600 to 900 | 1.5 to 2.5 |
|
| |
| |
Next » |
| |
|
